Tighter Scrutiny Needed for PCB Cleaning Agents


Reading time ( words)

PCB cleanliness on the assembly floor is now getting more attention, due to tiny residues and contaminants being left on assemblies after new, advanced assembly processes. Cleaning methodologies, testing, analysis, and special chemistries are being taken to a new level to assure customers of ultraclean boards to avoid costly latent issues.

Board cleanliness is especially critical for mil/aero and medical applications. The right types (and amounts) of cleaning agents must remove flux residues to assure the integrity of processes such as bonding and conformal coating. During the coating process, if residues result in poor wetting or delamination, they can cause assembly failures and ultimately lead to field failures.

In today’s assemblies, there are growing numbers of advanced packages like land grid arrays (LGAs), fine pitch BGAs, micro BGAs, micro CSPs, and the list goes on. Packages such as LGAs are flush to the board, and they have bumps, not balls or spheres, like BGAs.

If a small amount of flux remains trapped under the board’s surface, it can change the characteristics of impedance, resistivity. This could also change what could have been a perfect eye diagram, and in general, change the optimal level of operation. Ultra cleanliness is even more critical if underfill or conformal coating is applied to a device.

It’s difficult to clean such a device after the board has been processed. Therefore, assembly personnel have to be absolutely sure they’ve taken every possible measure to assure devices and boards are ultraclean. If residues are left in the conformal coating or underfill, then these contaminants are trapped inside the capsule and hinder device performance.

Read the full column here.


Editor's Note: This column originally appeared in the April 2014 issue of SMT Magazine.

Share

Print


Suggested Items

One Fish, Two Fish, Red Fish, Blue Fish: Same Industry, New Look

05/22/2020 | I-Connect007 Research Team
Learning a lesson from challenges is one thing, but implementing changes based on those lessons is quite another. I-Connect007 regularly surveys leaders in the electronics industry to bring you important and relevant information that helps you make better decisions. What lessons have you learned during the COVID-19 crisis, and what changes have you made?

Process Ionic Contamination Test (PICT) Standard Roundtable With Industry Experts

04/22/2020 | I-Connect007
With standards committees set to release the first of four new test standards, industry experts discussed the process ionic contamination test (PICT) standard, which was recently approved by the IEC for publication. Roundtable participants included Teresa Rowe, senior director of assembly and standards technology at IPC, Graham Naisbitt, chairman and CEO of Gen3, Jason Keeping, corporate process development at Celestica, and Doug Pauls, principal materials and process engineer at Collins Aerospace.

SMTA Europe’s Electronics in Harsh Environments Conference and Exhibition: A Taste of Things to Come

04/14/2020 | Pete Starkey, I-Connect007
SMTA Europe’s Electronics in Harsh Environments Conference has become a must-attend annual event; unfortunately, it also became another casualty of the COVID-19 lockdown. Scheduled to take place in Amsterdam, the Netherlands, from April 21–23, 2020, it has now been postponed until December 1–3. Pete Starkey reports on a preview seminar presented by SMTA Europe.



Copyright © 2020 I-Connect007. All rights reserved.